We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Vszerda 20cm adapter cable, large 4-pin to small 4-pin connectors

Vszerda

Vszerda Big 4 Pin to Small 4Pin Convert Cable 20CM

SKU CH-PKW2-KDEAX

Converts a standard Molex power connector to a floppy-drive power plug with a 20 cm cable

  • Connects legacy floppy drives to modern power supplies using a 20 cm adapter cable
  • Powers older IDE devices from standard Molex connectors with the 20 cm length
  • Fits tight chassis spaces thanks to the short 20 cm cable run
  • Supplies reliable power to FDD units via the small 4-pin plug conversion

Connectivity

This adapter cable converts a standard large 4-pin Molex power connector into a smaller 4-pin floppy drive connector. It allows older floppy disk drives or compatible peripherals to draw power from a modern power supply. The 20 cm length provides enough reach for typical internal routing inside a desktop chassis.

Thermals noise and power

As a passive wiring harness the cable generates no heat and produces no audible noise during operation. It simply transmits the voltages supplied by the power supply unit to the attached device. Power draw depends entirely on the connected floppy drive and adds no measurable overhead of its own.

How it compares

Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.

Price $13.99
Cheaper than about 55% of the 7,839 comparable items (median $14.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect the 20 cm cable between the large 4-pin Molex and the floppy drive's small 4-pin socket?

Plug the big 4-pin end into a free Molex connector from the power supply, then attach the small 4-pin end to the floppy drive's power port, ensuring both click fully into place.

Will the connectors or wire insulation degrade and need replacement over time?

The cable is a passive wire assembly; under normal desktop use the connectors and insulation last the life of the system and do not require scheduled replacement.

More in Internal PSU & Riser Cables

Similar items