We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Weller chisel soldering tip, silver metal, 0.031 inch width

Weller

Weller Soldering Tip Chisel 0.031 In 0.79 mm

SKU CH-QBPK-2BKRF

Chisel soldering tip measuring 0.031 inch wide, compatible with 1GLZ4 and WSP80 pencils

  • Product typeChisel
  • Chisel shape delivers broad contact for efficient heat transfer
  • 031 inch tip width enables precise work on small joints
  • Compatible with 1GLZ4 and WSP80 pencils for direct fit
  • New condition ensures full performance from first use

Weller Chisel Tip for 1GLZ4 and WSP80

This Weller chisel tip fits the 1GLZ4 and WSP80 soldering pencils. It is made for precision soldering work where a flat, tapered end is required. The tip size is 0.031 inches (0.79 mm). Buyers who need a conical or bevel profile for different joint access should choose another tip shape.

Thermals and Power Draw

The tip reaches working temperature quickly when used with the compatible WSP80 pencil rated at 80 watts. Heat transfers efficiently across the chisel face for consistent joint quality. Normal operation produces no audible noise from the tip itself. Buyers needing higher thermal mass for large ground planes will require a heavier tip geometry.

How it compares

Measured against everything we stock in Soldering Irons & Stations, at today’s prices. Recalculated every night.

Price $5.99
Cheaper than about 95% of the 802 comparable items (median $25.99).

Specifications

Product
Brand nameWeller
Product typeChisel

Questions about this item

How do I install the chisel tip on my WSP80 pencil, and which step is often missed?

Slide the 0.031 in chisel tip onto the WSP80 pencil barrel until it seats fully, then tighten the retaining nut securely; the step often missed is not seating the tip completely before tightening.

What maintenance will this 0.79 mm chisel tip need during its service life?

Clean the tip regularly with a damp sponge or brass wool while hot, re-tin it after each use, and replace it once the iron plating wears through at the 0.031 in working face.

More in Soldering Irons & Stations

Similar items