We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey 44-pin DB44 male-to-male cable, 0.5 m length

WMtec

WMtec DB44 44-pin male to male extension cable .5m

SKU CH-0PD0-80M32

A 0.5-metre pure-copper DB44 extension cable with 44 pins in three rows for CNC programmer signals

  • Pure copper conductors ensure reliable signal transmission
  • Male-to-male DB44 connectors extend existing cables directly
  • 44-pin three-row layout matches CNC programmer interfaces
  • Half-metre length keeps workstations tidy without excess slack

DB44 extension for CNC programmers

This 44-pin male-to-male cable extends a DB44 connection by half a metre. It uses pure copper conductors in a three-row layout to carry programmer signals between equipment. The straight-through wiring matches standard DB44 pinouts so the link works without adapters. It suits workshops that need a short, reliable link between a CNC controller and a programming station.

Half-metre length fixes reach limits

The .5 metre length is the critical spec; it only bridges gaps up to that distance. Buyers who need a longer run across a cabinet or between separated racks cannot use this cable. No other lengths are offered in this listing.

How it compares

Measured against everything we stock in Fiber Optic Patch Cables, at today’s prices. Recalculated every night.

Price $7.99
Cheaper than about 94% of the 812 comparable items (median $29.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

What does the .5 m length mean for signal quality in a CNC setup?

The half-metre run keeps attenuation low, so the 44-pin signal stays clean between the programmer and the machine.

How does the DB44 interface limit data throughput?

The 44-pin DB44 connector carries only the pins the CNC programmer needs, so bandwidth is defined by that pin count rather than a higher-speed standard.

More in Fiber Optic Patch Cables

Similar items