We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five tungsten-steel spiral router bits, 3.175 mm diameter, 32 mm length, one-flute up-down cut

YINGHUA

YINGHUA 5pcs 3.175X32 One Flute UP DOWN Cut Spiral Carbide Mill Tool Cutters

SKU CH-ANGW-5EBAP

Set of five 3.175 mm carbide compression cutters with up-down spiral flutes for clean CNC routing of wood and board materials

  • Product typeRight-Angle Drills
  • Five-piece set covers multiple jobs
  • 175 mm diameter suits fine detail work
  • 32 mm length reaches deeper cuts
  • Up-down spiral gives clean edges on both faces
  • Tungsten steel construction resists wear

5-Piece Carbide Compression Cutters

This set contains five tungsten-steel spiral mill cutters sized 3.175X32 mm. Each bit features a single up-down flute that compresses wood fibres for cleaner edges on CNC routers. The pack suits woodworkers who need ready-to-run replacements for dull or broken compression bits.

Replaces Worn Single-Flute Bits

Swap them in when existing one-flute compression cutters leave frayed edges on plywood, density board or solid wood. The up-down geometry shears both faces simultaneously, so the upgrade pays off on double-sided laminates and particleboard where tear-out ruins finish quality.

Check Shank Fit and Material Limits

Verify your collet or ER holder accepts a 3.175 mm shank before ordering. The cutters are rated for wood-based materials only; they are not intended for metal, plastic composites or hazardous substances. Operators must be 18 or older.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $133.99
Pricier than about 66% of the 2,412 comparable items (median $81.99).

Specifications

Product
Product typeRight-Angle Drills

Questions about this item

What shank diameter fits the 3.175 mm cutters?

Each cutter has a 3.175 mm shank that fits a matching collet or chuck.

How do I install the up-down spiral bits without damaging the flute?

Tighten the collet evenly so the 32 mm cutting length clears the workpiece and the flute stays centred.

When should I replace the tungsten-steel cutters?

Replace them when the up-down edges dull or chip on wood, plywood or particleboard.

More in Power Drills, Drivers & Cutting Bits

Similar items