We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat red cable with four SATA connectors each end 50cm long

Aomoproing

Aomoproing SAS 4 SATA Host to 4 SATA 7pin 6Gbps Cable 50cm

SKU CH-2VEX-GBWQZ

Connects four SATA drives to a four-port host controller using a 50cm cable rated for 6Gbps SAS

Cable Length 50 cm

  • Connect four drives from one controller with a single cable
  • Supports 6 Gbps SAS specification for high-speed data transfer
  • 50 cm length fits standard server and RAID chassis layouts
  • Straight 7-pin SATA connectors on both host and device ends
  • Enables four-drive SATA target connections from a 4-port SAS host

SAS 4 SATA Host Cable

This 50 cm cable bridges a 4 SATA host connector to four individual SATA 7 pin targets. It meets the 6Gb/s SAS specification for internal server and RAID deployments. The assembly is new and ready for immediate installation.

Suited for RAID arrays and multi-drive servers

Builders expanding a single controller port into four drive connections will find the pinout matches standard SATA 7 pin headers. Systems that only provide individual SATA ports or external eSATA links cannot use this breakout design.

6Gb/s SAS compliance decides fit

The cable is rated to the 6Gb/s SAS standard, so the host controller and backplane must support that signalling rate. If the infrastructure runs at a different specification the link will not operate as intended.

How it compares

Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.

Price $13.99
Typical for this category: the median of 1,954 items is $13.99.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Other versions of this model

1 more in the same range

Questions about this item

How can I verify the 6Gbps link is active after connecting the cable?

The host controller or RAID BIOS will report each attached drive at 6Gbps; check the negotiated speed in the controller utility or operating-system disk tool.

What connectors are included and are any adapters required?

The cable has a 4 x SATA 7-pin host connector on one end and four separate SATA 7-pin drive connectors on the other; no extra adapters are needed.

Which length should I choose for a standard server chassis?

The 50cm length fits typical 2U or 4U server drive bays and keeps routing tidy inside the case.

More in SATA & eSATA Drive Cables

Similar items