Belkin A3L791-10-RED Cat 5E network ethernet cable 10 ft red

Cat 5E patch cable for 10/100 networks

This Belkin A3L791-10-RED is a 10 ft unshielded twisted-pair cable terminated with RJ45 connectors on both ends. It is rated Cat 5E and exceeds the performance requirement for that category. The 50-micron gold-plated contacts are PowerSum tested for clean transmission. The red jacket helps identify the link in a busy patch panel.

Suits 10 and 100 Base-T LAN links.

Use it to connect a PC, switch, router or wall outlet where 10/100 Base-T speed is sufficient. The Cat 5E rating and unshielded design make it a cost-effective choice for basic home or office wiring. Builders who need certified Gigabit or 10 Gigabit throughput should look at higher-category shielded cables instead.

Verify port type and required reach before ordering

Confirm both endpoints present standard RJ45 jacks; the cable will not fit proprietary or smaller connectors. Measure the route between devices to ensure the 10 ft length provides enough slack without excess coil. No driver or configuration is needed — the link is passive and works immediately on compatible hardware.