STARTECH SATA36RA1 36in Right-Angle SATA Cable
- Cable Connectors
- Red
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a 22-pin SATA drive to an LP4 power and SATA data port at 6 Gbps, 19.7 in, two-pack
This 22-pin cable combines a 15-pin power connector and a 7-pin data connector into a single assembly, converting an LP4 IDE 4-pin source to SATA for hard drives, SSDs or optical drives. It suits builders adding SATA storage to older power supplies or extending existing SATA runs without extra cables.
Verify that your power supply or adapter provides a standard LP4 4-pin Molex output and that the target drive uses a native SATA 15-pin power plus 7-pin data interface. The cable is 19.7 inches (50 cm) long, so measure the routing path inside your chassis to confirm reach before ordering.
The 26 AWG oxygen-free copper cores maintain SATA III 6 Gbps speeds during extended reads and writes, limited only by the connected drive’s rating. Braided insulation prevents heat build-up under continuous load, and the latch-equipped data connector resists vibration-induced disconnects during long RAID rebuilds or large file copies.
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | XMSJSIY |
| Model name | XMSJSIY Round |
| Product type | SATA |
| Product color | Black |
| Performance | |
| Rated speed | 6 Gbit/s |
| Ports & slots | |
| Connector details | Sata |
| Connector gender | Male-to-Female |
Each cable combines a 15-pin SATA power connector and a 7-pin SATA data connector into one 22-pin assembly, letting you power and transfer data to a drive without separate power or data cables.
The cable is rated for SATA III 6 Gbps and is backward compatible with SATA I and SATA II, so it will run at the full speed of any SATA drive you connect.
It supports the maximum SATA III transfer rate of 6 Gbps; actual throughput will be limited by the drive and controller you attach.
More in SATA & eSATA Drive Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?