Cable Leader Cat6 Non-Booted Ethernet Cable 25ft Gray 24AWG 550MHz

25ft Cat6 patch cable for dense installs

This 25-foot Cat6 Ethernet cable delivers a reliable Gigabit wired connection with a non-booted RJ45 design built for high-density patch panels and keystone jacks. The gray jacket uses 24AWG bare copper conductors in four twisted pairs, terminated with 50-micron gold-plated contacts for corrosion resistance. It is tested to 550MHz, exceeding the Cat6 minimum, and supports 10G over short runs. The cable is backward compatible with Cat5e for a direct upgrade in data centers, server rooms and structured cabling.

Check port density and boot clearance

Verify that your patch panel or keystone jack spacing accepts non-booted plugs, as the low-profile design is intended for tight side-by-side ports where a molded boot would not fit. Confirm the 25-foot length reaches between your switch, router or patch panel and the endpoint without excess slack. Ensure the devices on both ends use standard RJ45 ports for Gigabit or 10G Ethernet, and that the run stays within the Cat6 distance limits for the desired speed.

Fits high-density racks and frees airflow

The non-booted plug seats cleanly in crowded 1U or 2U patch panels, improving airflow and simplifying cable management in racks and cabinets. Bare copper conductors and gold-plated contacts maintain signal integrity across routers, switches, PCs and PoE devices. RoHS compliant with UL, cUL and ETL listings, it integrates into existing Cat5e or Cat6 infrastructure without re-termination. The C6102 family offers multiple lengths and colors to match your labeling scheme.