Monoprice Inc. 140885 Flat Cat6 Network Ethernet Cable 10 ft Black 30AWG 550MHz
- Networking Patch Ca…
- 10 ft (3.05 m)
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 7 ft white Cat6 patch cable with snagless boots, 24 AWG stranded conductors and 50 µm gold-plated RJ45 connectors rated for 550 MHz bandwidth
This seven-foot white Cat6 patch cable uses 24AWG stranded UTP construction rated at 550MHz. It terminates in RJ45 male connectors on both ends with 50 micron gold-plated staggered pins and snagless bubble boots. The cable exceeds Category 6 EIA/TIA specifications and carries a CM fire rating with ETL verification. It is built for end-to-end Cat6 performance in gigabit networks.
The staggered pin layout and four twisted pairs limit cross-talk for reliable 10/100 Base-T and Gigabit Ethernet runs. Backwards compatibility covers existing Category 5e and Category 5 infrastructure. Buyers who require shielded cable for noisy environments should look at something else. Runs longer than the supported channel distance need a different solution.
The 550MHz rating on 24AWG stranded conductors is the single specification that confirms the cable can sustain gigabit speeds across the full seven-foot length. This figure appears in the Category 6 test report and the ETL verification. Without it the link may fall back to lower speeds or fail certification.
Measured against everything we stock in Ethernet & LAN Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product color | White |
| Ports & slots | |
| First connector | RJ45 |
| Second connector | RJ45 |
The cable is 7ft long with RJ45 male-to-male connectors on both ends, so it spans typical desk-to-wall or patch-panel runs while the staggered-pin design keeps the plug profile narrow for tight ports.
Push each RJ45 plug straight in until the latch clicks; the moulded bubble boot flexes back during insertion then springs forward, preventing the latch from hooking neighbouring cords when you pull the cable later.
Replace it if the 50-micron gold contacts show visible wear, the staggered pins become bent, or the snagless boot splits — any of those will increase cross-talk and drop the 550 MHz Category 6 margin.
More in Ethernet & LAN Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?