Cables To Go 27192 Cat6 network ethernet cable snagless unshielded yellow 7 ft 2.13 m

What this cable is and who needs it

The Cables To Go 27192 is a Cat6 unshielded twisted-pair patch cable with RJ45 male connectors on both ends. It is built for voice, data and video distribution in gigabit Ethernet networks. The 7 ft yellow jacket allows easy colour coding in patch panels or desktop runs. It meets TIA/EIA-568-B-2.1 draft 9 standards and supports bandwidth up to 550 MHz.

What to check before ordering

Verify that your switch, router or wall jack uses standard RJ45 ports and that a 7 ft run reaches between the two devices without tension. Confirm the installation path can accommodate an unshielded cable; environments with strong EMI may require shielded alternatives. The snagless boot adds strain relief but still needs a clear port opening. No tooling is required beyond a simple push-click connection.

Behaviour under sustained load

Bonded-pair construction maintains twist spacing to the termination point, keeping Near-End Crosstalk low during continuous high-throughput traffic. Impedance and structural return loss are reduced per the Cat6 specification, so signal integrity holds steady over long transfers rather than only in short bursts. The moulded boot protects the latch from repeated insertion cycles in busy rack or desk environments.