CMPLE 2.5mm stereo cable 90° downward

Flexible 90° HDMI port saver

This male-to-female adapter bends the HDMI connection 90 degrees downward to relieve strain on the cable and the device port. It fits tight spaces behind televisions, monitors, projectors or consoles where a straight plug would protrude too far. The passive design works with any HDMI cable or source without configuration. Builders who need an upward-facing angle instead should choose the 270-degree variant.

Protects ports during frequent changes

The coupler absorbs the wear of repeated plugging and unplugging so the fixed port on the display or player stays intact. It needs only a standard HDMI male socket on the device and a female cable end to operate. No external power or active circuitry is required, leaving the signal path unchanged. Installations with side-mounted or recessed ports may find the bend direction mismatched.

Passive signal path under constant use

Because the adapter contains no electronics, it adds no latency or heat during sustained 4K 3D playback. The gold-plated contacts maintain conductivity over many insertion cycles without active equalisation. Cable weight is supported by the angled housing rather than the device port, reducing long-term mechanical stress. Users requiring signal boosting for runs beyond standard cable lengths will need a separate active solution.