Dogfish Technology Shark 2.5 64G SATA internal SSD
- 2.5 in (6.35 cm)
- Internal SSD
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 2.5" SATA internal SSD with 60GB capacity and 3D NAND flash delivering up to 540MB/s read and 500MB/s write speeds
Capacity 60GB
The Dogfish Technology Shark 2.5 60G is a 60GB internal solid state drive built for consumer desktops and laptops. Its 2.5 inch form factor and SATA interface make it a direct replacement for mechanical hard drives in older systems.
The drive measures 100mm by 69mm by 6.8mm and weighs 100g, fitting standard 2.5 inch bays with a 7mm height profile. A SMI controller manages 3D NAND flash, while built-in ECC, bad block management, TRIM, NCQ and DevSleep support maintain data integrity and low power states during everyday operation.
Sequential reads reach up to 540 MBps and writes up to 500 MBps over the SATA III link, with the supplier noting peaks of 550 MBps read and 400 MBps write. The SATA bus caps throughput well below modern PCIe speeds, and the 60GB capacity restricts the amount of software and media that can reside on the drive.
Measured against everything we stock in Internal NVMe & SATA SSDs, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Shark |
| Product line | Shark 2.5 60G |
| Model name | Shark SSD 2.5 60G |
| Total capacity | 60 GB |
| Product type | Internal Solid State Drive (SSD) |
| Intended use | Consumer |
| Performance | |
| Sequential read speed | Up to 540 MB/s |
| Sequential write speed | Up to 500 MB/s |
| Storage | |
| NAND flash type | 3D NAND |
| Controller chip | SMI |
| Ports & slots | |
| Interface type | SATA III |
| Size & build | |
| Form factor | 2.5 in (6.35 cm) |
| Overall height | 100 mm |
| Overall width | 69 mm |
| Product depth | 6.8 mm |
| Product weight | 100g |
| More details | |
| Mean time between failures | 1,000,000 h |
Other versions of this model
The SATA III link limits sequential throughput to the drive's rated 540 MBps read and 500 MBps write.
Yes, at 6.8 mm thick it slides into any standard 7 mm 2.5-inch slot.
Set the controller to AHCI mode, then let the OS issue TRIM — skipping AHCI is the common mistake.
More in Internal NVMe & SATA SSDs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?