We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black SATA power splitter cable with 15-pin male connector and two female connectors, 8 inch length

EN-Labs

EN-Labs IDE23SATA8 SATA Power Splitter Cord 15-pin Male to 2 Female 8 inch 20AWG

SKU CH-R31Z-TSB2B

Splits one 15-pin SATA power connector into three with an 8-inch 20AWG copper cable supporting 12V, 5V and 3.3V devices

  • Connector count4
  • Connector genderMale to Female
  • Product typeCable Splitters
  • Product colorMulti-Color
  • Overall length6 in - 10 in
  • DetailsType :SATA power splitter cable Length:8 in Conductor:20AWG
  • Powers three drives from one SATA connector
  • 20 AWG copper conductor delivers stable current
  • 8 inch length keeps cable runs tidy
  • Male plug with gender changer fits tight ports
  • Supports 12V 5V 3.3V SATA devices

One cable powers three drives

The EN-Labs IDE23SATA8 is an 8 inch SATA power splitter built with 20AWG copper conductors. It accepts a single 15-pin male connector and provides two additional 15-pin female ports. A pass-through gender changer on the input side keeps the chain intact. The cord suits builders adding SSDs, HDDs or optical drives without extra power supply leads.

Steady delivery across all ports

Each branch carries 12V, 5V and 3.3V rails simultaneously so every attached device receives its rated voltage under continuous load. The 20AWG copper cores limit resistance over the short run preventing voltage sag when multiple drives spin up together. No active circuitry is present so reliability depends on the source supply and connector seating.

Plug in and route the short tails

Installation is a simple push fit onto the power supply lead and each drive backplane. The 8 inch length keeps cable clutter low but demands that drives sit close to the splitter or to each other. Misaligned pins or loose latch engagement are the typical faults so verify each connector clicks home before powering on.

How it compares

Measured against everything we stock in Y-Splitter Power Cables, at today’s prices. Recalculated every night.

Price $4.99
Cheaper than about 95% of the 433 comparable items (median $13.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

Product
Brand nameEn-Labs
Model nameIDE23SATA8
Product typeCable Splitters
Product colorMulti-Color
Ports & slots
Connector count4
Connector genderMale to Female
Size & build
Overall length6 in - 10 in

Questions about this item

Does the 20AWG copper conductor handle the 12V, 5V and 3.3V lines without overheating when three drives run all day?

The 20AWG copper wire is rated for the 12V, 5V and 3.3V rails that SATA devices draw, so continuous operation across three drives stays within normal thermal limits.

What power connector must my PSU already provide for the male end to plug in?

Your power supply needs a standard 15-pin SATA power connector; the splitter's male end mates directly with it.

Will the pass-through male connector still fit alongside older Molex-to-SATA adapters I already use?

Yes, the pass-through 15-pin male connector occupies the same space as a regular SATA power plug, so it sits next to legacy adapters without interference.

More in Y-Splitter Power Cables

Similar items