We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver cylindrical 6.0 mm end mill with two flutes and necked shank

M.A. Ford

M.A. Ford 13523605N3 End Mill Necked 6.0Mm

SKU CH-RNEN-HHFZA

A two-flute necked end mill with a 6.0 mm diameter for aluminium machining

  • Product typeCutting Tools
  • Precision necked design for deep-pocket milling
  • Two-flute geometry clears chips in aluminium
  • 0 mm cutting diameter matches standard tooling
  • California Prop 65 warning informs safe handling
  • Ships direct from M.A. Ford for factory-fresh condition

M.A. Ford 6.0 mm Necked End Mill

The M.A. Ford 13523605N3 is a new Tuffcut Al two-flute end mill with a 6.0 mm diameter and a necked profile. It is a cutting tool intended for aluminium milling where extended reach and chip clearance are required.

For aluminium milling with reach needs

Machinists who need a necked geometry for deep pockets or thin walls in aluminium will suit this tool. Buyers who require more flutes, a different coating or a non-necked design should look at something else.

Fits standard 6.0 mm tool holders

The shank matches common 6.0 mm collets and holders so no special clamping is needed. The necked section frees clearance for deeper features without increasing overall tool length.

How it compares

Measured against everything we stock in Yard Ornaments & Garden Statues, at today’s prices. Recalculated every night.

Price $33.99
Cheaper than about 58% of the 1,271 comparable items (median $40.99).

Specifications

Product
Brand nameM.A. FORD
Product typeCutting Tools

Questions about this item

What shank diameter collet or holder do I need for the 6.0 mm necked end mill?

The cutter has a 6.0 mm shank, so use a 6 mm ER collet, shrink-fit holder or hydraulic chuck with a matching 6 mm bore.

Will the two-flute geometry work on my older manual knee mill?

Yes, the two-flute design runs on any mill with a 6 mm tool holder, including manual machines, though feed rates will be lower than on CNC.

How can I confirm the necked profile is cutting correctly after the first pass?

Measure the stepped diameter behind the flutes; it should match the neck relief shown in the tool drawing and leave no witness marks on the wall.

More in Yard Ornaments & Garden Statues

Similar items