We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver cylindrical end mill with two flutes and necked shank

M.A. Ford

M.A. Ford 13547240N End Mill 12.0mm

SKU CH-T4EM-WDY44

Two-flute necked end mill with 12.0 mm diameter for aluminium machining

  • Product typeCutting Tools
  • TuffCut AL coating optimises aluminium cutting
  • Two-flute geometry clears chips in soft metals
  • Necked profile reaches deep cavities without interference
  • 0 mm diameter suits standard tool holders
  • California Proposition 65 warning informs safe handling

12.0 mm Two-Flute End Mill

This M.A. Ford 13547240N Tuffcut Al end mill has a 12.0 mm cutting diameter and a necked, two-flute design. It is built for aluminium and other non-ferrous metals. Machinists and CNC operators use it for high-speed slotting and profiling jobs.

Aluminium machining specialists

The tool suits shops cutting aluminium, brass or plastic where chip evacuation matters. It is not for hardened steels, exotic alloys or operations that demand a higher flute count for finish passes. Buyers who need a different diameter or a coated variant should look at other listings.

12.0 mm cutting diameter

The 12.0 mm diameter is the single figure that decides fit for your holder and toolpath. Orders of $75 or more ship free from the manufacturer. A California Proposition 65 notice applies because the product contains a listed chemical.

How it compares

Measured against everything we stock in Yard Ornaments & Garden Statues, at today’s prices. Recalculated every night.

Price $83.99
Pricier than about 78% of the 1,271 comparable items (median $40.99).

Specifications

Product
Brand nameM.A. FORD
Product typeCutting Tools

Questions about this item

What shank diameter does the 12.0 mm end mill need to fit my tool holder?

The cutter has a 12.0 mm diameter, so select a collet or holder that matches that shank size.

How do I install the necked 2-flute end mill without damaging the flutes?

Clamp on the shank only, keep the necked section clear of the holder, and tighten evenly to avoid run-out.

When should I replace this Tuffcut Al end mill?

Replace it when the cutting edges show visible wear, chipping, or when surface finish on aluminium degrades.

More in Yard Ornaments & Garden Statues

Similar items