We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cylindrical metal end mill with two flutes, silver finish

M.A. Ford

M.A. Ford 135B75000 Tuffcut Al 2 Flute End Mill 3/4 statue

SKU CH-4DPP-SPTNK

Two-flute Tuffcut AL end mill designed for aluminium machining with efficient chip evacuation

  • Product typeCutting Tools
  • Precision milling with Tuffcut Al coating
  • Two-flute design clears chips efficiently
  • 3/4 inch cutting diameter for heavy cuts
  • M.A. Ford quality for consistent results
  • California Prop 65 chemical warning applies

Product Identity

The M.A. Ford 135B75000 Tuffcut Al is a two-flute end mill designed for aluminium cutting. It is intended for machinists and fabricators who need a dedicated tool for non-ferrous milling tasks.

Suitability

This cutter suits workshops focused on aluminium profiling and slotting where a two-flute geometry aids chip evacuation. Buyers requiring tools for hardened steel, high-temperature alloys or multi-material job shops should look at alternative geometries.

Accessories Impact

The product ships directly from the manufacturer with no additional holders, collets or coating options included. Users must supply their own tool-holding system and verify machine compatibility before use.

How it compares

Measured against everything we stock in Yard Ornaments & Garden Statues, at today’s prices. Recalculated every night.

Price $238.99
Pricier than about 90% of the 1,271 comparable items (median $40.99).

Specifications

Product
Brand nameM.A. FORD
Product typeCutting Tools

Questions about this item

What tool holder or machine spindle is required to fit the 3/4 shank of the M.A. Ford 135B75000 end mill?

A 3/4 inch collet, end-mill holder or shrink-fit chuck matching your machine’s taper is needed to secure the shank.

Can this two-flute aluminum cutter run on an older manual mill with lower spindle speeds?

Yes, it will cut aluminum on a manual mill; reduce feed to stay within the machine’s speed range and use flood coolant.

How can I confirm the 135B75000 is cutting cleanly after the first pass?

Inspect the slot for a smooth, burr-free finish and measure the width to match the 3/4 cutter diameter.

More in Yard Ornaments & Garden Statues

Similar items