NEMIX RAM DDR5 384GB 4x96GB 4800MHz CL40 ECC RDIMM Supermicro H13SST-G memory upgrade

Exact-match DDR5 ECC RDIMM kit

This 384 GB kit contains four 96 GB DDR5 4800 MHz CL40 registered ECC RDIMMs built for the Supermicro H13SST-G motherboard. The modules run at 1.1 V and use a 2Rx4 rank layout that matches the board's memory controller requirements. They install in the standard 288-pin DIMM slots and are recognized at full capacity and rated speed without manual tuning.

Registered architecture for full-slot population

The registered design buffers address and command signals so the memory controller can drive all four slots at the rated 4800 MT/s. ECC corrects single-bit errors on the fly to prevent silent data corruption and unplanned reboots in production workloads. No heat spreader is fitted, so airflow from the server chassis cools the modules directly. Verify the motherboard manual for the approved DIMM population order before installation.

Upgrade from smaller or slower DDR5 RDIMMs

This kit replaces lower-capacity DDR5 RDIMM sets or slower-speed modules when the application demands 384 GB of registered ECC memory at the native 4800 MT/s rate. The jump is worthwhile when the workload exceeds the capacity of a two-DIMM configuration or when the current modules force a down-clock below 4800 MT/s. It does not fit systems that require UDIMM or SODIMM form factors.