Nippon Labs 60CAT6A-3GN 3 ft Cat6A network ethernet cable

Network cable for 10 Gigabit Ethernet

This Cat6A UTP patch cable connects routers, switches and workstations using RJ45 plugs on both ends. It is built for 10 Gigabit Ethernet over copper at distances up to 100 meters. The 3 ft green length suits short rack or desk runs. Stranded 24 AWG pure copper conductors keep the link flexible for frequent moves.

Thermals noise and power draw

Passive copper construction means no fan noise, no active cooling and zero power draw from the cable itself. The CM-rated PVC jacket meets standard flame-retardance requirements for in-wall or plenum-adjacent routing. Gold-plated contacts reduce contact resistance, limiting heat rise during sustained PoE loads. Unshielded twisted-pair design relies on pair geometry rather than a foil drain wire.

Deciding specification 500 MHz minimum frequency

The cable is rated for a minimum frequency of 500 MHz and tested to 550 MHz, which is the figure that qualifies it for 10 000Base-T operation. If your link only requires 1 000Base-T, a lower-category cable will also work. Buyers who need shielded construction for high-EMI environments should select an S/FTP alternative. The T568B wiring scheme matches most commercial patch panels.