Phobya 3-Pin Fan Extension Cable 80cm Black 3-Pack

Three 80 cm extensions for multi-fan builds

This pack supplies three 3-pin fan extension cables, each 80 cm long, so builders can reach distant motherboard headers without stretching stock leads. The black sleeving keeps the looms tidy inside windowed cases. They suit any system that needs extra fan length beyond the factory cables. The unshielded connectors also let a 4-pin PWM plug run on a 3-pin header when PWM control is not required.

Replaces short stock leads when headers are far away

Use these when the standard fan tails cannot reach the board in full-tower or dual-chassis layouts. The jump is worth it whenever cable routing forces a detour behind trays or through grommets that eat up slack. They do not add PWM functionality, so fans that rely on 4-pin speed control will run at fixed voltage instead.

Push-fit connectors need no tools

Each end presses onto the header or fan by hand; no crimping or soldering is involved. The only common snag is reversing the polarity — match the tab on the plug to the notch on the header before pushing. Because the connectors are unshielded, a 4-pin fan will lose its tachometer wire and report zero RPM to the BIOS.