Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Extends a motherboard HD Audio header by 30 cm with a black-sleeved female-to-male cable
This 30 cm cable extends the internal HD Audio header from the motherboard to a front-panel audio module. It carries microphone and headphone signals without the need to reroute the original loom. Builders fitting a case with a distant or repositioned front panel will find the extra reach essential. The black sleeving keeps the wiring tidy inside the chassis.
The cable adds no active components, so power draw and thermal output remain zero. Noise is limited to the mechanical rustle of the sleeve against other wires during assembly. Because it simply passes the existing motherboard audio lines, signal quality matches the board’s own header specification. No additional drivers or BIOS settings are required.
It substitutes the short HD Audio lead supplied with many cases or motherboards when that lead cannot reach the header. The upgrade is worthwhile whenever the stock cable falls short by more than a few centimetres. Builders whose front-panel audio ports already reach the header without strain gain no benefit from this extension.
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product color | Black |
| Size & build | |
| Cable length | 1 ft (0.3 m) |
Align the keyed HD Audio female connector on the cable with the motherboard header so the missing pin slot matches, then press the male end onto the front-panel module until it clicks; the black sleeve prevents snagging on nearby headers.
The sleeve is a fixed PET braid that resists abrasion and heat inside a chassis; it does not wear out under normal use and requires no maintenance or periodic replacement.
At 30 cm the cable stays well within the HD Audio specification for front-panel runs, so sustained use does not introduce audible noise or signal loss.
More in Internal PSU & Riser Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?