STARTECH SATA36RA1 36in Right-Angle SATA Cable
- Cable Connectors
- Red
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 20-inch male-to-female extension cable for internal SATA data connections
This 20 inch SATA male-to-female extension cable carries 7-pin internal SATA signals and supports SATA I, II and III speeds of 150, 300 and 600 MB/s. It is intended for technicians, service centres and builders who need extra reach when routing data cables inside a chassis.
The cable is passive and adds no active cooling, fan noise or power draw to the system. Its conductors are 26 AWG solid tinned copper with 28 AWG drain wires, wrapped in aluminum Mylar shielding and a PVC jacket rated to 80 degrees Celsius.
No software, adapters or mounting hardware are included; the product consists solely of the extension cable itself. The gold-plated contacts and impedance-controlled design preserve signal integrity at up to 4500 MHz, but the cable does not convert interfaces or add ports beyond the single male-to-female connection.
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Model name | SS-AZX20MPSS |
| Size & build | |
| Cable length | 1.66 ft (0.51 m) |
Connect the male end to the motherboard or controller SATA port, then plug the existing drive cable into the female end; the common mistake is reversing the ends, which leaves the drive unpowered because the male connector must face the host.
The 26 AWG solid tinned copper conductors and 15 µ gold-plated contacts are rated for 80 °C continuous operation; inspect the PVC jacket and shielding for cracking or kinks after repeated drive swaps and replace the cable if the jacket is damaged.
The 100 ± 15 ohm impedance and 6 dB maximum attenuation from 10 MHz to 4500 MHz set the signal-integrity ceiling; beyond the 1.66 ft length the eye diagram closes, so sustained 600 MB/s traffic is the practical ceiling before errors rise.
More in SATA & eSATA Drive Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?