We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green PCB adapter board with 80-pin SCA connector and 68-pin plus 50-pin SCSI headers

SMUGDESK

SMUGDESK SCSI SCA 80Pin to 68Pin & 50Pin Adapter Converter Board

SKU CH-J6M5-7WMGE

Converts 80-pin SCA SCSI drives to 68-pin and 50-pin interfaces for legacy server data recovery

  • Converts SCA 80pin to 68pin and 50pin SCSI for legacy drives
  • Onboard 4pin power connector supplies power to SCA hard disks
  • Jumper blocks allow SCSI ID and delay start configuration
  • Optimised PCB signal routing reduces interference for reliable data transfer
  • Suits server maintenance, retro builds and historical data recovery

SCA 80-Pin to 68/50-Pin Converter

This adapter board converts an SCA 80-pin SCSI interface into standard 68-pin Ultra SCSI and 50-pin narrow SCSI connectors. It is designed for technicians and hobbyists who need to access legacy SCA hard drives using older host controllers for data recovery or server maintenance.

Installation and Jumper Configuration

The board installs by connecting the SCA drive to the 80-pin socket and the host cable to the required 68-pin or 50-pin output. A 4-pin large D power connector must be attached to supply the drive. Onboard jumper blocks require manual configuration of SCSI ID and delay-start parameters; incorrect jumper settings are the most common cause of detection failures.

SCSI Interface Compatibility

This converter only bridges SCA 80-pin drives to 68-pin or 50-pin SCSI host interfaces. It does not support modern SATA or NVMe storage drives, so builders needing to connect those interfaces cannot use this board.

How it compares

Measured against everything we stock in SATA, IDE & M.2 Drive Adapters, at today’s prices. Recalculated every night.

Price $14.99
Cheaper than about 80% of the 1,721 comparable items (median $22.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

How can I confirm the adapter is working after connecting an SCA 80pin drive to my 68pin controller?

The system BIOS or SCSI utility should detect the drive at the configured SCSI ID and report its capacity without errors during the initial scan.

What comes with the board and what extra parts are needed for a complete setup?

The board includes the 80pin SCA slot, 68pin and 50pin connectors, a 4pin power input and jumper blocks; you must supply a 4pin power cable and the correct 68pin or 50pin SCSI cable for your controller.

Which onboard connector should I use — the 68pin or the 50pin — for my legacy server?

Match the connector to your host controller: use the 68pin Ultra SCSI port for wide SCSI controllers and the 50pin narrow SCSI port for older narrow SCSI controllers.

More in SATA, IDE & M.2 Drive Adapters

Similar items