Kanto SUB8VMW 8-inch 300W Sealed Powered Subwoofer White home audio speaker
- Single
- 300 W Peak Power
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Granite-finish rock speakers with 6.5" woofers and 1/2" tweeters deliver 80 W, 91 dB sensitivity and 40 Hz–20 kHz response for outdoor areas
A pair of 6.5-inch two-way speakers housed in UV-resistant rock enclosures. Each unit combines a polypropylene cone woofer with a coaxially mounted polyamide dome tweeter. The sealed voice-coil design and silicone-encased leads protect against moisture and temperature swings. Ideal for gardens, patios and poolside zones where a natural stone look is preferred.
Works well for installers needing discreet, weatherproof coverage across flower beds or lawns. Buyers wanting deep sub-bass extension, high-SPL party output or a dedicated subwoofer output should look at something else. The 8-ohm impedance matches most multi-zone amplifiers without extra matching transformers.
The 80-watt continuous rating defines the safe amplifier ceiling for each speaker. Exceeding this level risks thermal compression or driver damage during sustained playback. Pair with an amplifier rated at or below 80 watts per channel into 8 ohms for reliable long-term performance.
Measured against everything we stock in Home Speakers & Subwoofers, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Part number | ASM33615 |
| Product type | Indoor/Outdoor Speakers |
Use a stereo amplifier or receiver that delivers up to 80 watts per channel into an 8 ohm load; the speaker's 91 dB sensitivity means moderate power will drive it to loud levels.
Mixing impedances on the same amplifier channel changes the load seen by the amp; wire each pair on its own channel or use an impedance-matching selector to keep the amplifier stable.
Play a frequency sweep or pink-noise test tone at moderate volume and listen for smooth output down to the low bass and up to the highest treble without buzzing or drop-outs.
More in Home Speakers & Subwoofers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?