STARTECH NLWH-10F-CAT6A-PATCH 10 ft Cat6a network ethernet cable

White Cat6a patch cord for 10GbE

This ten-foot white cable is built to the Cat6a specification and tested to 500 MHz, making it suitable for 10GBase-T networks. The S/FTP shielding protects signal integrity in electrically noisy environments. It is aimed at installers and IT teams who need a reliable, standards-compliant link between switches, servers or wall outlets.

LSZH jacket and snagless connectors

The low-smoke zero-halogen jacket meets strict fire-safety requirements for plenum or public-space runs. Both RJ45 ends are molded and snagless, so the retaining clips resist breakage during repeated insertion or cable management. Strain-relief boots further reduce stress on the termination point, helping maintain consistent performance over the cable’s service life.

100 W PoE++ headroom and 10 ft reach

The construction supports Power over Ethernet up to 100 W, so it can deliver full PoE++ power to access points, cameras or lighting without a separate supply. At ten feet it covers typical rack-to-patch-panel or desk-to-wall distances with slack for routing. Runs that exceed this length or require higher bandwidth than 10GBase-T will need a different cable category or active extension.