Monoprice Inc. 140885 Flat Cat6 Network Ethernet Cable 10 ft Black 30AWG 550MHz
- Networking Patch Ca…
- 10 ft (3.05 m)
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Short white Cat8 patch cable with snagless RJ45 plugs, 2000 MHz bandwidth, S/FTP shielding and 100 W PoE support for 25 Gbps and 40 Gbps links
This six-inch white Cat 8 patch cord is built for dense rack or patch-panel work where every centimetre counts. It supports 25 and 40 gigabit Ethernet over its 2000 MHz bandwidth and carries up to 100 watts of PoE power. The S/FTP shielding and pure bare copper conductors keep signal integrity tight in high-interference environments.
The 2000 MHz Cat 8 specification is the single figure that decides whether this cable matches the port speed you are running. It qualifies the link for 25G and 40G BASE-T, so anything slower will work but anything faster will not. If your switch or NIC tops out at 10G you still get full performance, just with unused headroom.
Snagless boots protect the locking tabs during repeated inserts and pulls in crowded cabinets. The 26 AWG stranded conductors make the cord flexible enough to route around cable managers without kinking. LSZH jacket material meets low-smoke requirements for plenum or riser spaces where building codes apply.
Measured against everything we stock in Ethernet & LAN Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | StarTech |
The 2000 MHz bandwidth supports the full Category 8 frequency range, allowing 25 Gbps and 40 Gbps Ethernet signals to pass without loss over the rated distance.
The RJ45 interface is the standard for 25GBASE-T and 40GBASE-T, so the connector itself does not cap the 25 Gbps or 40 Gbps rates this cable is built for.
The snagless boot adds a small over-mould behind the RJ45 plug; allow a few millimetres extra depth behind the port so the latch can release without catching on adjacent cables.
More in Ethernet & LAN Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?