Sabrent EC-SSHD USB 3.0 to 2.5" SATA Hard Drive Adapter
- 4 In
- USB 3.0 to SSD/2.5…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects Seasonic or older Antec modular PSUs to three SATA drives with 18 AWG wiring and 50 cm main length
This cable converts a single 6-pin modular connector on compatible Seasonic or older Antec power supplies into three 15-pin SATA power connectors. It is intended for builders adding hard drives, SSD riser cards or other SATA-powered devices to those specific modular PSU lines.
The adapter uses 1007-standard 18 AWG tin-coated copper wire rated for typical SATA device currents. Total reach from the PSU connector to the first SATA plug is 50 cm, with 15 cm between each subsequent SATA connector, keeping cable routing tidy inside the case.
Under sustained load from multiple drives the 18 AWG conductors deliver stable power without excessive voltage drop across the 50 cm main length and 15 cm branch segments. The cable is not compatible with newer Antec units that use dual red ports or with any non-listed PSU brands.
Measured against everything we stock in SATA, IDE & M.2 Drive Adapters, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Case Fan Accessory |
Align the 6 pin male end with the single red modular port on the Seasonic X750 and push straight in until it clicks; do not force it into a port that has two red connectors because this cable only fits the older one‑red‑port layout.
The 18 AWG conductors are rated for continuous SATA power loads and do not have a scheduled replacement interval; inspect the insulation for cracking if the cable is repeatedly bent near the 6 inch SATA spacing.
The combined current draw of the three SATA devices must stay within the 6 pin port's rating on the PSU; exceeding that will trip the supply's protection before the cable itself becomes a bottleneck.
More in SATA, IDE & M.2 Drive Adapters
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?