Vertiv AS6B0NCVGNNXLKB 10kVA 9kW 208V Split Phase UPS 5min Runtime

10 kVA Split-Phase UPS for Critical Loads

This Vertiv Liebert unit delivers 10 kVA and 9 kW of online double-conversion power with a 208 V split-phase output. It is built for data-centre racks or tower deployments that need continuous clean power for servers, storage arrays and network gear. The system scales to 20 kVA in an N+1 redundant frame, so growing infrastructure can add capacity without replacing the chassis. Buyers who only need single-phase output or runtime beyond 5 minutes at full load should look elsewhere.

Rack-or-Tower Installation with Factory SNMP Card

The chassis measures 38 by 17 by 34 inches and weighs 510 lbs, so it requires a rated rack or solid floor space and mechanical assistance to position. Input uses a four-wire L-L-N-G connection across 200 to 240 V line-to-line voltages, and the 40–70 Hz auto-sensing input tolerates unstable grids. The SNMP/Webcard is already fitted, removing a common integration step. Installers must still provide external battery modules for extended runtime, and the 49-inch overall height may exceed standard 42 U rack clearance.

Five-Minute Full-Load Runtime Defines Sizing

At 100 percent load the VRLA battery set sustains output for 5 minutes; at half load the runtime extends to 15 minutes. This figure is the primary constraint for right-sizing the UPS to the protected equipment. If the connected load cannot be shed to half within that window, or if a longer bridge to generator start is required, additional battery cabinets must be specified. The operating range of 32–104 °F and 0–95 percent non-condensing humidity must also match the site environment.