VideoSecu CBHD1004-A1 4-pack 100ft BNC video power cable

Four-camera kit with 100 ft cables

This pack contains four 100 ft all-in-one video and power cables designed for CCTV and HD analog security cameras. Each cable carries both the video signal and DC power, simplifying installation by eliminating the need for separate wiring runs. The cables are constructed from pure copper and terminated with BNC male video connectors and 2.1 mm centre-positive power plugs. Two BNC-to-RCA adapters are included for additional connection flexibility.

Suits installers using AHD, CVI or TVI cameras

The cables support HD 960P and 720P formats as well as 960H, 700TVL and 1000TVL analogue cameras, making them a fit for mixed-resolution systems. They are not suitable for IP cameras that require Ethernet cabling or Power over Ethernet, nor for devices needing a different power connector polarity or voltage. Buyers who need longer individual runs or plenum-rated jacketing should look at alternative cable types.

Plug-and-play installation with minimal tools

Each cable arrives pre-terminated, so installation is a matter of connecting the BNC ends to the DVR and camera and plugging the 2.1 mm power leads into the respective power supplies. The most common issue is voltage drop over the full 100 ft length, which can cause unstable camera operation if the power supply cannot compensate. Ensure the power source delivers adequate current at the camera end and that BNC connections are fully seated to avoid video loss.