Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts four 8-pin PSU cables into a single 12VHPWR connector with a 90-degree angled head for RTX 3090 Ti, 4070 Ti, 4080 and 4090 graphics cards, supporting up to 600 W
This Vszerda adapter converts four 8-pin power connectors into a single 12VHPWR plug for modern graphics cards. The 90-degree down-angled design eases installation where clearance around the GPU power port is tight. It supports the PCIe 5.0 and ATX 3.0 standards with a 12+4 pin configuration. One cable reduces clutter and simplifies cable routing inside the case.
Suits builders who need to connect a 12+4 pin graphics card to a power supply that only provides 8-pin PCIe outputs. The right-angle plug helps when the card sits close to a side panel or drive cage. Not suitable for the older 12-pin connector found on the RTX 3090 series. Buyers whose PSU already has a native 12VHPWR output do not need this adapter.
The cable is rated for up to 600 W through the PCI-SIG 12VHPWR H+ interface, matching the requirement for high-end GPUs such as the RTX 4080 and 4090. Four 8-pin connectors on the supply side provide the necessary current. Verify that your power supply can deliver the required wattage across those four 8-pin ports before installing.
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The cable has a single 16-pin 12VHPWR end and four 8-pin PCIe plugs. You supply four 8-pin cables from your modular PSU; nothing else is required.
The adapter fits 12+4-pin cards such as RTX 3090 Ti, 4070 Ti, 4080 and 4090. It will not work with the 12-pin RTX 3090 series.
The PCI-SIG 12VHPWR H+ spec allows up to 600 W through the 12 power pins plus 4 signal pins, so a single cable can deliver the full rated power to a compatible GPU.
More in Internal PSU & Riser Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?