STARTECH SATA36RA1 36in Right-Angle SATA Cable
- Cable Connectors
- Red
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Connects a SATA power plug to two Molex 4-pin devices, extending reach by 20 cm
This cable converts a single SATA 15-pin male connector from the power supply into two Molex 4-pin female connectors. It allows systems without native SATA power outputs to run 3.5-inch hard disks and optical drives. The 20 cm length suits tight routing inside compact chassis. Builders adding older peripherals to modern power supplies will find it useful.
Passive copper conductors carry 12 V and 5 V rails without active cooling or added noise. The 18 AWG full-copper cores minimise resistive loss across the short 20 cm run. PVC sheathing insulates the conductors and resists heat from nearby components. No fan or semiconductor is present so the cable adds zero acoustic output.
The Y-splitter terminates in two Molex 4-pin female plugs spaced for side-by-side drive bays. A single SATA power lead from the PSU feeds both devices, freeing remaining SATA connectors for other hardware. The 20 cm reach connects drives mounted in adjacent 3.5-inch bays without strain. Systems already saturated with Molex loads should verify total rail capacity before adding this splitter.
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | OHKIKOME |
| Model name | OHKIKOME 2Pcs |
| Product type | SATA |
| Product color | Black |
| Ports & slots | |
| Connector gender | Male-to-Female |
Connect the 15-pin male end to the power supply SATA port, then attach each 4-pin female to a drive; the step often missed is seating both Molex plugs fully so the 12 V and 5 V lines make solid contact.
Inspect the PVC jacket and 18 AWG copper conductors periodically; replace the cable if the insulation cracks or the pins loosen after repeated drive swaps.
The shared 15-pin SATA connector on the power supply typically hits its current rating before the 20 cm cable or the dual Molex ends do.
More in SATA & eSATA Drive Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?