Vszerda 3-pin ARGB LED splitter extension cable, 30 cm, 26 AWG

30 cm ARGB splitter cable

The Vszerda 3-pin ARGB LED splitter extension cable adds three extra addressable RGB connections from a single motherboard 5 V header. It is built for PC builders who want to run multiple 5050, 3528 or 2835 LED strips or fans without soldering. The 30 cm length keeps routing tidy inside mid-tower and full-tower cases. The 26 AWG tinned-copper conductors handle the current required for typical addressable lighting loads.

4-pin female to 4×4-pin male layout

One 4-pin female plug accepts the motherboard’s +5 V 3-pin ARGB header, while four 4-pin male ends each drive a separate LED strip or fan. The arrow-aligned connectors enforce correct polarity so the data line, power and ground stay matched across every branch. This fixed pin-out means the cable only works with 3-pin addressable headers; it will not fit 2-pin, 4-pin RGB or 5-pin connectors.

80 °C rated PVC jacket under load

The soft PVC insulation and tinned copper wires are rated for continuous operation at 80 °C, so the cable remains stable when all four strips run at full brightness for extended periods. Firm sleeving resists abrasion and dust ingress during routine case maintenance. The plug-and-play design requires no tools, letting you verify the setup under sustained load immediately after installation.