Vszerda ATX 3.0 PCI-E 5.0 12VHPWR 90° UP Angled Extension Cable 17cm

12VHPWR Extension Cable for ATX 3.0 Builds

This 17 cm male-to-female extension adds a 90-degree upward bend to the 12VHPWR connector. It follows the ATX 3.0 and PCI-E 5.0 specification with a 12+4 pin layout rated for 600 W delivery. The 16 AWG conductors keep voltage drop low across the short run. It targets builders routing power to RTX 40-series or RDNA 3 graphics cards in tight chassis.

Verify Connector Orientation and Clearance

Confirm your power supply provides a native 12VHPWR header before ordering. Measure the distance from that header to the graphics-card socket; the 17 cm length suits compact routing only. Ensure the 90-degree upward angle points toward the side panel or motherboard tray without pressing against the GPU shroud. Check that the 12-pin power and 4-pin signal rows align with your card’s keying.

Suits Small-Form-Factor ATX 3.0 Systems

Ideal for ITX or mid-tower builds where a straight 12VHPWR cable would kink against the case wall or glass panel. Builders using longer PSU cables or needing a downward or sideways bend should look elsewhere. The fixed 90-degree upward profile cannot be rotated, so chassis with reversed motherboard layouts or bottom-mounted PSUs may require a different angle.