STARTECH SATA36RA1 36in Right-Angle SATA Cable
- Cable Connectors
- Red
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 50 cm copper cable connects an internal SATA male port to an external eSATA female socket for PS3 hard-disk data transfer
This 50 cm cable bridges an internal SATA 7-pin male header on a motherboard or PS3 to an external eSATA 7-pin female port for an external hard disk. Copper conductors carry data signals between the two connectors. The short length keeps signal attenuation low inside a compact build.
The SATA and eSATA standards share the same electrical signalling, so the cable works at the host controller’s native speed without protocol conversion. Total cable run including internal traces must stay within the specification’s maximum length to avoid errors. Shielding quality and connector latch retention determine real-world reliability more than the extender itself.
Verify that the host device provides a standard internal SATA 7-pin male port and that the external enclosure uses a matching eSATA 7-pin female socket. Confirm the 50 cm reach fits the routing path between the motherboard or PS3 backplane and the external drive bay. Ensure the system firmware recognises eSATA devices on the chosen port.
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Chenyang |
| Model name | SA-020-CY |
| Product type | eSATA |
| Ports & slots | |
| Connector details | Sata |
| Connector gender | Male |
| Size & build | |
| Conductor type | Copper |
This cable is offered only in a 50 cm length; it connects the internal SATA 7-pin male port on the motherboard to an external eSATA 7-pin female port for the drive.
The link runs at the native SATA/eSATA rate of the drive and controller; the 50 cm copper conductors add no measurable latency or bandwidth loss.
The connectors are passive and support the full SATA/eSATA specification; the practical ceiling is set by the drive and host controller, not the cable.
More in SATA & eSATA Drive Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?