We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black SATA power splitter cable with one input and five right-angle connectors 18AWG

Vszerda

Vszerda SATA 3.5/2.5 inch 1 to 5 Power Splitter Cable 18AWG

SKU CH-0FS5-XDBR3

Splits one SATA power connector into five for 3.5 and 2.5 inch drives using 18AWG wire

  • Splits one SATA power connector into five for multiple drives
  • 18 AWG wire gauge handles standard hard-drive power loads
  • Supports both 3.5 inch and 2.5 inch SATA devices
  • Straight-through wiring keeps installation simple and reliable

Power Splitter for SATA Drives

This cable converts a single SATA power connector into five, supporting both 3.5 and 2.5 inch hard drives or solid-state drives. It is built with 18AWG conductors for reliable current delivery. The design suits builders adding multiple storage devices to a system with limited power-supply leads.

Thermals Noise and Power Draw

Passive wiring produces no audible noise and adds negligible heat inside the chassis. Power draw depends entirely on the drives attached, not on the splitter itself. The 18AWG gauge handles typical SATA device loads without voltage drop under normal operation.

How it compares

Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.

Price $15.99
Pricier than about 60% of the 1,954 comparable items (median $13.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect the 18AWG SATA power splitter so all five drives receive power without overloading the PSU?

Plug the single male SATA connector into your power supply, then attach each of the five female SATA plugs to the 3.5 or 2.5 inch drives; the 18AWG wire handles the combined current, but keep total draw within the PSU rail limit.

When should I replace the 18AWG SATA power splitter cable?

Replace it if any connector feels loose, the insulation shows cracks, or you notice intermittent drive spin-ups, which signal worn contacts or fatigued 18AWG conductors.

More in SATA & eSATA Drive Cables

Similar items