STARTECH SATA36RA1 36in Right-Angle SATA Cable
- Cable Connectors
- Red
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Three-pack of 15-pin SATA power splitters, each dividing one male connector into two female ports for drives and optical units
This three-pack of SATA power splitter cables turns a single 15-pin SATA connector from your power supply into two female SATA power connectors. It lets you run additional hard drives, solid-state drives or optical drives without needing extra power-supply leads. Each cable is 8 inches long and carries digital power signals.
The SATA power standard delivers a fixed voltage and current budget per connector, so every drive you attach shares the same rail. Adding too many devices on one splitter can exceed the rail’s rating and cause instability or shutdown. The 15-pin layout also means the cable only fits SATA power ports, not other power interfaces.
Plug the male end into the power supply and the two female ends into your drives; no tools are required. The most frequent issue is loose seating, which interrupts power to one or both drives. Routing the short 8-inch length in a crowded case can strain the connectors, so leave a little slack to avoid accidental disconnection.
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Mbiydeg |
| Product type | DisplayPort to DVI |
| Performance | |
| Rated speed | 1 Hz |
| Ports & slots | |
| Connector details | 15 Pin Sata |
| Connector gender | Male to 2x Female |
Each cable splits one 15 Pin SATA connector into two female SATA power connectors, so a single power supply lead can run two drives; the pack contains three identical cables.
At 8 inches the cable suits typical internal routing between a PSU and nearby drive bays; measure your specific layout to confirm the reach before installing.
The 1 hertz figure is a supplier data entry artifact; power splitters carry DC current and have no signalling frequency, so the rating does not affect real-world operation.
More in SATA & eSATA Drive Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?