Jansicotek A0108 DisplayPort 2.1 cable 16 ft 80 Gbps

Jansicotek A0108 DisplayPort 2.1 Cable 16 ft

The Jansicotek A0108 is a male-to-male DisplayPort 2.1 cable measuring 16 ft with an 80 Gbps bandwidth rating. It targets PC builders and gamers who need a long run between a graphics card and a high-refresh-rate monitor or television. The cable supports resolutions up to 16K at 60 Hz with DSC, plus 8K at 120 Hz and 4K at 240 Hz.

Plug-and-play installation

Installation is a simple push-fit of the DisplayPort 2.1 connectors on each end; the latching mechanism secures the plug until the release button is pressed. The triple-shielded design and solid copper conductors resist electromagnetic interference that can cause flicker or signal drop-out on long runs. A common issue is forgetting to seat the connector fully until the latch clicks, which results in no picture or an unstable link.

DisplayPort 2.1 bandwidth ceiling

The cable delivers the full 80 Gbps specified for DisplayPort 2.1, enabling 16K 60 Hz, 8K 120 Hz and 4K 240 Hz when both source and display support those modes. At 16 ft the copper conductors are near the practical limit for 80 Gbps without active signal boosting, so runs longer than this may require an active optical cable. Buyers who need cable runs beyond 16 ft or who require bandwidth above 80 Gbps cannot use this passive copper model.