Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Extends 4-pin PWM or 3-pin fans by 30 cm with sleeved cables in a two-pack
This 30 cm extension cable adds reach between a motherboard header or fan controller and a 4-pin PWM fan. The pack contains two black cables with premium weave sleeving for a clean internal look. Each assembly uses a 4-pin connector that also accepts 3-pin fans. It suits builders who need extra length for tidy cable routing.
Stock fan cables often fall short in larger cases or when routing behind a motherboard tray. This extension bridges the gap without splicing or crimping. The jump is worth it when the original lead cannot reach the desired header or when a neat, sleeved run is preferred. It is not for builders who need a splitter to run multiple fans from one header.
The cable carries the PWM signal and power continuously with no active components to degrade. Premium weave sleeving resists abrasion during long-term vibration from spinning fans. Connectors maintain secure contact through thermal cycles inside a running system. No performance change occurs over time because the link is purely passive.
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | Extension Cable |
| Product color | Black |
| Ports & slots | |
| Connector count | 2 |
The cable measures 30 cm end to end, so measure your routing path before ordering.
Align the keyed tab on the 4-pin connector with the missing pin on the 3-pin header; the fourth wire simply hangs free and PWM control is disabled.
Inspect the premium weave sleeving for fraying or crushed wires after any case rebuild; replace the cable if the 4-pin connectors feel loose or show bent pins.
More in Internal PSU & Riser Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?