Vszerda PWM 4-pin 1-to-3 fan splitter cable 10 inch 2-pack
Connects three PWM fans to one motherboard header with 10-inch sleeved cables
Model 2 Pack
- 1 Pack$5.99
- 2 Pack$7.99
- Connect three PWM fans to one motherboard header
- 10 inch length suits compact builds
- Black sleeved jacket keeps cables tidy
- Single tach wire gives stable RPM reading
- All fans follow identical PWM speed curve
Versatile PWM splitter cable for multi-fan setups
This Vszerda cable splits one motherboard PWM 4-pin header into three fan connections. Builders can run three fans from a single header to simplify internal wiring. The 10 inch length suits typical mid-tower layouts. Two cables are included in the pack.
Sustained operation keeps all fans in step
PWM speed control is supported so fan curves apply equally across the three connectors. Only the full 4-pin connector passes an RPM signal back to the board, preventing conflicting tachometer readings. The other two connectors lack the sense pin, so monitoring stays stable. Three-pin fans attached to the splitter run at full speed without PWM regulation.
Black sleeved jacket aids tidy routing
A black net jacket covers the wires for a cleaner look inside the case. The sleeve protects the conductors during assembly and helps cables blend with dark interiors. Connectors are keyed for standard 4-pin and 3-pin fan headers. No additional mounting hardware is required.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $7.99
- Cheaper than about 91% of the 7,839 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Other versions of this model
5 more in the same range
Questions about this item
Does the 10 inch PWM splitter cable add noticeable heat or electrical load when three fans run all day?
The cable itself draws negligible power and produces no measurable heat; all current flows through the motherboard header, so thermal impact depends on the fans, not the splitter.
What must my motherboard provide for the 1-to-3 PWM splitter to function?
A single 4-pin PWM header is required; the cable carries the PWM control signal to all three fans while only one fan returns an RPM reading.
If I plug a 3-pin fan into one of the splitter's 4-pin connectors, will it still follow the PWM curve?
No, any 3-pin fan connected to the splitter runs at full voltage continuously because it lacks the fourth PWM control wire.
More in Internal PSU & Riser Cables
Similar items
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
EN-Labs 4PINHUB5P 5-port PWM fan hub 45cm
- 1.47 ft (0.45 m)
- Fan power splitter…
STARTECH LP4PCIEX8ADP 6.1 in LP4 to 8 Pin PCIe Power Cable Adapter
- 6.1 in (15.5 cm)
- Cable Connectors
EN-Labs LP424TX425CM Molex to 4-Pin Fan Power Splitter Cable 10 inch Black Sleeved 12V
- 10 in (25.4 cm)
- Fan power splitter…
STARTECH TX3SPLITTER 6.1 in TX3 Fan Power Splitter Cable
- 0.5 ft (0.15 m)
- Cable Connectors
EN-Labs PWMHUB5 5 Port 4Pin PWM Fan Splitter Hub 40CM
- 1.3 ft (0.4 m)
- PWM 4pin fan hub sp…










