STARTECH SATA36RA1 36in Right-Angle SATA Cable
- Cable Connectors
- Red
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Splits one SATA 15-pin power connector into two for 2.5" and 3.5" drives with 22 cm 18AWG cable
This SATA power Y-splitter turns one 15-pin male connector into two 15-pin female connectors so a single PSU lead can feed two drives. It is built for 2.5-inch SSDs, 3.5-inch HDDs and optical drives that use standard SATA power ports. The cable is not intended for any other interface and the supplier warns that mis-connection can damage components.
The 22 cm length suits tight drive cages or short runs between stacked bays, while the 32 cm option gives extra reach for full-tower layouts. Each branch carries the full 5-wire set including the 3.3 V line, so drives that require 3.3 V power will start correctly. The 18 AWG conductors and 2.1 mm outer diameter limit voltage drop on typical consumer drives, but very long daisy-chains or high-spin-up-current arrays may exceed the wire’s comfort zone.
The single deciding specification is the 15-pin SATA power connector with all five voltage lines present, including 3.3 V. If your drive or backplane expects that complete pinout the splitter will work; if the device uses a different power interface or omits the 3.3 V line you need a different adapter.
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | XAGMODSHN |
| Model name | 7666540383329 |
| Product type | Computer-usb-cables |
| Product color | 22 cm |
| Ports & slots | |
| Connector details | Usb |
| Connector gender | Male-to-Female |
The 22 cm cable provides two 15-pin female connectors from one male plug, so you can power a 3.5" HDD and a 2.5" SSD simultaneously if the drives are mounted close together.
Measure the yellow, red and orange wires at each female connector with a multimeter; you should see 12 V, 5 V and 3.3 V respectively on the 5-digit pinout.
The box contains only the 18 AWG Y-splitter cable itself; no screws, brackets or additional power leads are supplied.
More in SATA & eSATA Drive Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?