BUCIER SF-105-0.5M-XY U.2 SFF-8639 68pin Male to Female Extension 50cm

U.2 SFF-8639 68-pin extension cable

This 50 cm male-to-female cable extends a U.2 NVMe PCIe link by half a metre. It uses copper conductors and carries the 68-pin SFF-8639 interface between drive and backplane or controller. The assembly is supplied new and intended for internal cabling in storage builds.

Fits between U.2 drive and host connector

The male plug attaches to the host or backplane while the female receptacle accepts the drive’s U.2 connector, freeing routing space inside the chassis. It requires a matching SFF-8639 port on each side and does not adapt to SATA or SAS devices. No additional power leads or active circuitry are included.

Supports PCIe 2.0 at 2 GB/s and PCIe 3.0 at 4 GB/s

At the rated speeds the cable handles typical NVMe workloads with headroom for sequential reads and writes. Bandwidth drops to the 2.0 ceiling if the host or drive negotiates the older revision, so maximum throughput depends on the connected endpoints. The half-metre length keeps signal loss low for standard U.2 distances.