NEMIX RAM 192GB (6x32GB) DDR5-5600 ECC RDIMM CL46 1.1V 2Rx8 Supermicro H13SSW

192GB DDR5-5600 ECC RDIMM kit for Supermicro H13SSW

This 192GB kit contains six 32GB DDR5-5600 registered ECC modules built to the exact rank, voltage and timing the Supermicro H13SSW memory controller expects. It is designed for servers that require full-capacity population with registered DIMMs and on-the-fly error correction. The modules operate at 1.1V with a CAS latency of CL46 and use the 288-pin RDIMM form factor required by this platform. Buyers needing unbuffered UDIMMs or laptop SODIMMs should look elsewhere.

Registered ECC architecture with 2Rx8 organisation

The registered buffer reduces electrical load on the memory controller, allowing all six slots to run fully populated at the rated 5600 MT/s speed without signal degradation. ECC circuitry detects and corrects single-bit errors automatically, preventing silent data corruption and unplanned reboots in production workloads. Major OEM Samsung, Micron or Hynix DRAM chips provide the underlying reliability. No heat spreaders are included, so airflow across the bare modules must be adequate for sustained operation.

Verify motherboard population rules

Server memory support varies by exact model and BIOS revision; consult the Supermicro H13SSW manual for approved DIMM population sequences, maximum supported capacity per slot and any firmware requirements. The kit provides 192GB across six 2Rx8 modules, so every slot must accept a dual-rank registered DIMM at 1.1V. Systems limited to fewer slots, lower maximum capacity or different voltage rails will not recognise the full kit.