Vszerda SATA to 2x 3/4-pin fan splitter cable 10 inch black
Connects two 3-pin or 4-pin case fans to a 15-pin SATA power plug with a 10-inch black sleeved cable
Style PWM 1 x2
- PWM 1 x2$7.99
- PWM 1x3$6.99
- PWM 1x4$6.99
- PWM 1x5$7.99
- Power two fans from one SATA connector
- 10-inch sleeved cable keeps wiring tidy
- 12 V supply via standard 15-pin SATA plug
- 22 AWG copper cores rated UL 1007
- PWM control not supported — fans run at fixed speed
Vszerda SATA fan splitter cable
This Vszerda adapter connects two 3-pin or 4-pin case fans to a single SATA power connector from the PSU. It is intended for builders who want to add extra cooling without using motherboard fan headers. The 10 inch black sleeved cable keeps the installation tidy inside the case.
Thermals noise and power delivery
Power comes directly from the PSU SATA interface at 12V so the fans run at full speed continuously. Only two pins are energised on each fan connector which means PWM control and speed throttling are not available. The 22AWG copper conductors handle the current for up to two fans without voltage drop.
No PWM speed control
The single specification that decides fit is the lack of PWM functionality; the cable cannot throttle fan speed or report RPM to the motherboard. Buyers who need automatic fan curves or quiet low-speed operation should look for a motherboard-header splitter instead.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $7.99
- Cheaper than about 80% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Other versions of this model
5 more in the same range
Vszerda SATA to 2x 3-pin 4-pin fan power splitter cable 10 inch black
Questions about this item
How do I connect the SATA 15-pin male plug to my PSU and avoid the common mistake of expecting PWM speed control?
Plug the SATA 15-pin male connector into any free SATA power port on the PSU. The cable only energises two pins on each fan header, so PWM speed control and throttling are not possible; fans will run at full 12 V constantly.
Will the black sleeved jacket or the 22 AWG copper wires need replacement after long-term use inside a case?
The UL 1007 22 AWG copper conductors and black sleeved jacket are rated for continuous 12 V operation and do not have a scheduled replacement interval; inspect visually during routine cleaning and replace only if insulation damage or connector wear appears.
What is the practical limit when running two fans continuously from this 10-inch splitter?
The SATA power connector and 22 AWG wires set the current ceiling; with only two pins energised per header, sustained 12 V delivery to both fans is the limiting factor, not cable length or PWM circuitry.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATA36RA1 36in Right-Angle SATA Cable
- Cable Connectors
- Red
LUOM US217 SATA cable 3-pack 18 in straight right-angle locking latch
- 1 in (2.54 cm)
- SATA III
Nippon Labs SATA-0.5RR 0.5m SATA cable right-angle pair
- 1.64 ft (0.5m)
- SATA II
LUOM US217 SATA III cable 3-pack 18 in 90° + 180° locking latch
- 1 in (2.54 cm)
- SATA III
Nippon Labs SATA3L1.5FT-90/180RD 1.5 ft SATA III cable 90 to 180 degree
- 1.5 ft (0.46 m)
- SATA III
EN-Labs 5PKSATAIII15CMBK 5-pack SATA 3.0 6Gbps cable 6" black locking latch
- 6 in (15.2 cm)
- SATA Data Cable










